Sharma Engineering’s

Sharma Engineering Logo

Know In Detail About Magnetic Calibration and Equipment

People use the term magnetization at par with magnetic saturation. If you want your product to reach a certain magnetic level, you should do the magnetic calibration. The process is similar when the field range of the product goes to a low saturation point. Use calibration equipment in Kolkata from reputable manufacturers for a guaranteed outcome.  

When to Perform Magnetic Calibration? 

The experts perform magnetic calibration during the following situations – 

• When the product requires a specific field range 

With this requisite, it can meet the standards for optimal performance. See that it happens within a certain level of mechanical tolerance.  

• For magnetic compensation 

The professionals perform this for products with varying mechanical tolerance levels. 

• To stabilize magnetic behaviour 

The main aim is to prevent variations during the operation. Factors like thermal influence or external demagnetizing fields are at play.  

• To compensate the component variable  

This occurs because of using different materials to make the product.

At times, devices like electric motors or sensors experience a loss of magnetization.  It happens from exposure to de-magnetic fields or thermal variations. During this time, the specialists use a magnet calibrator. It enables the proper functioning of the products and stabilizes the behaviour. 

For correct calibration, you should stress on product saturation. The experts do it unless it reaches a specific level of magnetization. Automation in the process lets you get feedback control. You can measure every valid degree of magnetization. Further, it clarifies the next voltage levels as the function of difference between actual and target levels. Continue repeating the process unless you attain a new target.   

The magnetic calibrator equipment operates on capacitor discharge units. It requires a higher accuracy level while applying charging voltage. Hence you should rely on this device to make it functional. 

When to do Magnetic Stabilization? 

Permanent magnets suffer from losses if driven beyond a critical parameter. At this point, you can notice the unaltered loss. This is when demagnetization helps restore the original magnetic output. Otherwise, it causes differences between initial and subsequent operations. 

You can precondition the magnets if a similar situation persists. Thermal stabilization is a good solution to correct problems that occur from a temperature rise. If there is loss from external stress, perform stabilization.

Meet the Professionals

Sharma Engineering manufactures advanced calibration equipment as per international standards. It helps stabilize the behaviour of industrial magnets and compensates for variability.

Leave a Comment

Your email address will not be published. Required fields are marked *

Scroll to Top